Page 1 of 1
series 1 crossmember
Posted: Fri Apr 03, 2026 7:01 pm
by thegoose
looking for where to buy a series 1 80" rear frame crossmember.
thanks
Re: series 1 crossmember
Posted: Fri Apr 03, 2026 7:11 pm
by mepham55
Most
Likely you will have to order from the UK unless you can find someone local to fabricate one.
https://www.johncraddockltd.co.uk/jc159 ... hassi.html
Re: series 1 crossmember
Posted: Fri Apr 03, 2026 8:51 pm
by thegoose
do you know where i can find the exact dimensions to fabricate?
Re: series 1 crossmember
Posted: Sat Apr 04, 2026 7:51 am
by StuartC
Ask the question on the UK forum....LRSOC (Land Rover Series One Club)....you might get lucky.
Someone may have a dimensional drawing they would be willing to send.
Not a difficult fabrication....and I think about 14 ga. steel.
You will never know if you don't ask.
Stuart
Re: series 1 crossmember
Posted: Sun Apr 05, 2026 8:41 pm
by StuartC
Just did a little rechecking on frame material thickness.
sheet steel 12ga....2.5mm....0.105" thickness
Re: series 1 crossmember
Posted: Wed May 06, 2026 4:40 pm
by thegoose
StuartC wrote: Sun Apr 05, 2026 8:41 pm
Just did a little rechecking on frame material thickness.
sheet steel 12ga....2.5mm....0.105" thickness
i made a post. maybe i'll bring a measuring tape and pen/pad to the 22nd campout get some measuring done :)