The Rover-Landers of BC

Hi, who makes a heavy duty CV Joint that doesnt cost an arm and a leg but is of good quality still?

Hey how are you.....flooded yet? Hope not. Anyway I'm not sure what vehicle you need a CV for, but I have purchased a number good HD items reasonably priced from rovertracks.com

I believe he has just re-sourced some HD CV’s

Cheers

Yes, just last week, Rovertracks re-released the 4340 CV, shaft set.

$660 USD for both CVs and halfshafts!!!

http://rovertracks.com/products/axles.html

The CV joints are the same as used by Longfield in the 30 spline Toyota setup (other than the stub geometry). All should be much stronger than the Rover ring and pinion.

It is for the later style axles only, so if you have an early axle, you'll need to swap to the newer hubs and spindles.