Page 1 of 1
Building a 90
Posted: Thu Sep 08, 2005 6:46 pm
by HeadDamage
Posted: Thu Sep 08, 2005 9:15 pm
by DaveB
Shiny! Is it covered with tin foil? :lol: Never seen one that pretty before.
Dave
Nice Frame!
Posted: Fri Sep 09, 2005 7:20 am
by Revor
I cold galvinized my firewall 3 years ago and it seams to be holding up well. I would recomend it as a solution to the rust that tends to happen there...
Looking forward to the updates!
Ryan
Posted: Fri Sep 09, 2005 11:34 am
by red90
That looks like it turned out very nicely. Where did you get it done? And if you don't mind, what was the cost?
Posted: Fri Sep 09, 2005 11:39 am
by HeadDamage
Industrial Galvanizing here in Calgary. This is the fourth frame over the last 20 years that I have had done there, they do good work. It was $345 including my winch bumper, skid plates and other small parts. I have a bulkhead that they did about 5 or ten years ago that we never used, I will now be using it. I don't know if the alum body work is going to look as good but the steel should be nice and rust free for years to come :D
