yellow knob connects to...

Message
Author
philchan1974
Over Inflated
Posts: 170
Joined: Tue Aug 29, 2017 3:51 pm
Location: Mission BC

yellow knob connects to...

#1 Post by philchan1974 » Sun May 09, 2021 7:35 pm

As i've just removed my seat box and tub to prep my frame, i had to remove the yellow 2wd/4wd knob to get the centre console off.

As i was looking at it i noticed I could pull the end of the assembly out of the transmission (the pin that sits in the actual transfer case). Being a newbie - is this correct? It should just be able to come out like "that" ?

cbalme
Slave Cylinder
Posts: 437
Joined: Fri Apr 14, 2017 2:05 pm
Location: Cobble Hill, Vancouver Island

Re: yellow knob connects to...

#2 Post by cbalme » Sun May 09, 2021 9:20 pm

There should be a screw that is screwed into the transfer case that the linkage pivots on. It is not a big deal and shifting the red knob from low back to high should allow you to put the pin back in place.

philchan1974
Over Inflated
Posts: 170
Joined: Tue Aug 29, 2017 3:51 pm
Location: Mission BC

Re: yellow knob connects to...

#3 Post by philchan1974 » Mon May 10, 2021 10:20 am

Thanks Colin. I will check this...

Post Reply