series 1 crossmember

Forum rules
By posting in this forum, you agree not to post anything abusive, obscene, vulgar, slanderous, hateful or threatening, Doing so may lead to you being immediately and permanently banned.
Post Reply
Message
Author
thegoose
Junior Craftsman
Posts: 26
Joined: Wed Nov 17, 2021 12:53 am

series 1 crossmember

#1 Post by thegoose » Fri Apr 03, 2026 7:01 pm

looking for where to buy a series 1 80" rear frame crossmember.

thanks
Top
mepham55
Spanner Man
Posts: 835
Joined: Fri Mar 26, 2004 8:38 pm
Location: Victoria, BC, Canada

Re: series 1 crossmember

#2 Post by mepham55 » Fri Apr 03, 2026 7:11 pm

Most
Likely you will have to order from the UK unless you can find someone local to fabricate one.

https://www.johncraddockltd.co.uk/jc159 ... hassi.html
Top
thegoose
Junior Craftsman
Posts: 26
Joined: Wed Nov 17, 2021 12:53 am

Re: series 1 crossmember

#3 Post by thegoose » Fri Apr 03, 2026 8:51 pm

do you know where i can find the exact dimensions to fabricate?
Top
StuartC
Wing Nut
Posts: 156
Joined: Fri Apr 08, 2022 6:28 pm
Location: Courtenay, BC

Re: series 1 crossmember

#4 Post by StuartC » Sat Apr 04, 2026 7:51 am

Ask the question on the UK forum....LRSOC (Land Rover Series One Club)....you might get lucky.
Someone may have a dimensional drawing they would be willing to send.
Not a difficult fabrication....and I think about 14 ga. steel.

You will never know if you don't ask.

Stuart
Top
StuartC
Wing Nut
Posts: 156
Joined: Fri Apr 08, 2022 6:28 pm
Location: Courtenay, BC

Re: series 1 crossmember

#5 Post by StuartC » Sun Apr 05, 2026 8:41 pm

Just did a little rechecking on frame material thickness.
sheet steel 12ga....2.5mm....0.105" thickness
Top
thegoose
Junior Craftsman
Posts: 26
Joined: Wed Nov 17, 2021 12:53 am

Re: series 1 crossmember

#6 Post by thegoose » Wed May 06, 2026 4:40 pm

StuartC wrote: Sun Apr 05, 2026 8:41 pm Just did a little rechecking on frame material thickness.
sheet steel 12ga....2.5mm....0.105" thickness
i made a post. maybe i'll bring a measuring tape and pen/pad to the 22nd campout get some measuring done :)
Top
Post Reply

Return to “Vehicles and Parts Wanted”