Wanted...
To suit S2A 109" SW
-6 cylinder engine, good core or better
-Front axle, 109"" reinforced housing ideal
-Transmission (may be able to retrieve the original)
Thanks in advance!
Julian
Parts Wanted
Forum rules
By posting in this forum, you agree not to post anything abusive, obscene, vulgar, slanderous, hateful or threatening, Doing so may lead to you being immediately and permanently banned.
By posting in this forum, you agree not to post anything abusive, obscene, vulgar, slanderous, hateful or threatening, Doing so may lead to you being immediately and permanently banned.
-
mepham55
- Spanner Man
- Posts: 835
- Joined: Fri Mar 26, 2004 8:38 pm
- Location: Victoria, BC, Canada
-
jacobko
- Crank Case
- Posts: 126
- Joined: Mon Mar 19, 2018 12:09 pm
Re: Parts Wanted
Where are you located? I have one from a NADA Station Wagon that was swapped for a chevy engine shortly after purchase. The 6 cylinder has quite low millage and would be good for a rebuilt, but it has been sitting in storage for about 50 years.
-
mel rover
- Half Shaft
- Posts: 132
- Joined: Sat Dec 04, 2010 8:51 pm
Re: Parts Wanted
I have a used head from a 6cyl for $200 I live in Oliver
Thanks Rob
Thanks Rob
-
InterMechanico
- Little Wheel
- Posts: 86
- Joined: Sun Oct 11, 2020 4:53 pm
Re: Parts Wanted
Thank you jacobko. I've sent you a PM.
-
InterMechanico
- Little Wheel
- Posts: 86
- Joined: Sun Oct 11, 2020 4:53 pm
Re: Parts Wanted
Thank you Mepham55.
I'm tempted. Could ship them here for a few hundred dollars I suppose. I'll look into it.
I'm tempted. Could ship them here for a few hundred dollars I suppose. I'll look into it.
-
InterMechanico
- Little Wheel
- Posts: 86
- Joined: Sun Oct 11, 2020 4:53 pm
Re: Parts Wanted
Thank you mel rover.
I'll make a note of it for future reference. May take you up on your offer
I'll make a note of it for future reference. May take you up on your offer