Cv Joint

Post Reply
Message
Author
tony
Little Wheel
Posts: 83
Joined: Sun Mar 04, 2007 3:33 pm
Location: Fraser Valley
Contact:
Contact tony

Cv Joint

#1 Post by tony » Sun Nov 15, 2009 11:27 pm

Hi, who makes a heavy duty CV Joint that doesnt cost an arm and a leg but is of good quality still?
Top
PaulC

#2 Post by PaulC » Mon Nov 16, 2009 6:47 am

Hey how are you.....flooded yet? Hope not. Anyway I'm not sure what vehicle you need a CV for, but I have purchased a number good HD items reasonably priced from rovertracks.com

I believe he has just re-sourced some HD CV’s

Cheers
Top
red90
Defender of the World
Posts: 1509
Joined: Mon Mar 08, 2004 7:19 pm
Location: Calgary

#3 Post by red90 » Mon Nov 16, 2009 8:28 am

Yes, just last week, Rovertracks re-released the 4340 CV, shaft set.

$660 USD for both CVs and halfshafts!!!

http://rovertracks.com/products/axles.html

The CV joints are the same as used by Longfield in the 30 spline Toyota setup (other than the stub geometry). All should be much stronger than the Rover ring and pinion.

It is for the later style axles only, so if you have an early axle, you'll need to swap to the newer hubs and spindles.
Top
Post Reply

Return to “Q&A on anything technical or mechanical”