Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Disable your ad blocker to continue using our website.
-
LandyAndy
- Maxi Drive
- Posts: 319
- Joined: Tue Nov 30, 2004 2:54 pm
- Location: Revelstoke
#1
Post
by LandyAndy » Thu Oct 06, 2011 8:08 am
The '55 2L donor engine for my S1 is going to need either a rebore or a liner fitting as #1 cyl was full of water when I pulled the head off. Any recomendations for a good machine shop that's worked on these old spread bore engines before ?
Anyone have any spare engine parts..... pistons.... NOS bearings ?
Cheers,
Andy
-
swamijake
- Out of Africa
- Posts: 417
- Joined: Tue Jan 08, 2008 1:31 pm
- Location: Lower Mainland
#2
Post
by swamijake » Thu Oct 06, 2011 1:52 pm
-
LandyAndy
- Maxi Drive
- Posts: 319
- Joined: Tue Nov 30, 2004 2:54 pm
- Location: Revelstoke
#3
Post
by LandyAndy » Thu Oct 06, 2011 3:33 pm
Thanks for the heads up but until we get the old one out and the bore worked on I won't know what we'll need. It'll either get sleeved & bored back to std or be over sized.
Hopefully back to std & we can reuse the old piston... fingers crossed :wink:
-
LandyAndy
- Maxi Drive
- Posts: 319
- Joined: Tue Nov 30, 2004 2:54 pm
- Location: Revelstoke
#4
Post
by LandyAndy » Mon Oct 10, 2011 10:01 am
Any good leads on an engine rebuilding shop ?
-
mange rover
#5
Post
by mange rover » Mon Oct 10, 2011 3:43 pm
i have a few parts block and polished crank and there may be more these are from a 59.2a
