Series 2a 109 Four Door- Doors, Rear Tub and etc. Alignment!

[Dijan1993]

Well as I get closer to the body and assembly to the frame of my 109 2a... Is anyone aware of any videos that are really helpful to the assembly process or of things that they may have done to build their own series truck? I could use any and all helpful information.

[cbalme]

There was a video from Brittanica Restorations a few years ago about lining up the doors and bulkheads.

Overall the main point was that the tub does not have any adjustment so you start from the back and work your way to the front. You will need to add spacers depending on the gaps you want.

I found aligning the bulkhead worked best with a ratchet strap from the window hinges to the front frame horn to fine tune it.

Make sure every bolt is loose as well while adjusting the pillars and bulkhead

[Dijan1993]

Thank you Colin,
I will use your advice, onward and upward!

[Dijan1993]

Colin, Maybe you know... I would like to find more about my Series and I have the VIN. is there a website or etc. that I can contact to get the breakdown of the series IE date of manufacture and etc or even a build sheet?

[cbalme]

https://www.clifton.nl/index.html?calvin.html

Here’s a link to a VIN decoder, hope it’s helpful!

[TimberPig]

The link I posted in your other thread gives more of this info as well.

[Dijan1993]

Thanks everyone...Close to driving...

First roll out of the garage.MOV

(3.99 MiB) Downloaded 28 times

[oldgravy]

Thanks everyone...Close to driving...
First roll out of the garage.MOV

Nice work!